Using Auto-Place (Single Symbol) (3:30)

Detailed Step-by-Step Guide for Using Auto Placement in Inspire

Objective: This guide provides instructions on using the auto placement feature in Inspire for single symbol identification and placement, differing from the multi-symbol, multi-sheet approach of inspired search.

Step 1: Access the Assemblies Tab

• 1.1 Open your project in Inspire and navigate to the 'Assemblies' tab.
• 1.2 Choose an assembly to work with, such as a duplex receptacle.

Step 2: Setting Up Auto Placement

• 2.1 Check the assembly placement method at the top of the assembly configuration. It usually defaults to manual.
• 2.2 Switch the placement method to 'Auto' to enable automatic processing.

Step 3: Configure Auto Placement Settings

• 3.1 Adjust the blanket parameters that will be applied to all identified symbols within the sheet.
• 3.2 Define general properties such as part lists, dimensions, and any specific naming conventions.

Step 4: Apply and Verify Properties

• 4.1 After setting the desired properties, click 'Apply Properties' to save your settings.
• 4.2 Ensure all configurations are correct before proceeding to actual placement.

Step 5: Initiating Auto Placement

• 5.1 Click on the 'Auto Place' icon to start the search for the specified symbol within the sheet.
• 5.2 Be strategic with the placement box to ensure optimal symbol identification.

Step 6: Review and Adjust Identified Symbols

• 6.1 Review the preview images generated by the auto search.
• 6.2 Interact with the results, deselecting any inaccurately identified symbols by clicking the check mark.

Step 7: Finalize Placement

• 7.1 Confirm all selections and hit 'Save Changes' to finalize the symbol placements.
• 7.2 Use the 'Place Symbol' option to apply symbols to the sheet, ensuring all placements are correctly marked.